Top synthetic blood penetration test equipment factory? GESTER instruments is a textile testing equipment manufacturers, company which integrates research & devolepment, prodution and sales in one. So far, GESTER instruments owns two production factories and four sales teams for textile testing instruments, footwear testing equipments, children’s product tester and furniture tester. We have applied for dozens of patents from the State Intellectual Property Office. As one of the best textile testing equipment manufacturers with 20+ years experience, With GESTER instruments’s advanced design, excellent manufacturing technology and strict quality management, GESTER instruments has build the longterm cooperation relationship with tops of international testing institutes as SGS, Bureau Veritas, TUV, UL and Intertek, etc. We specialized in textile testing instruments. See even more details at splash resistance tester.

The AC servo drive system with low noise and wide range of applications. Pneumatic Bursting Strength Tester Test Methods: Constant Time Bursting. The tester bring saving and printing functions and support on-line operation. Provide on-line interfaces, professional detection software which can be used to analysis testing result. Summary of Test Method: A specimen is clamped over an expandable diaphragm. The diaphragm is expanded by fluid pressure to the point of specimen rupture. The difference between the total pressure required to rupture the specimen and the pressure required to inflate the diaphragm is reported as the bursting strength.

Correct use of computerized universal testing machine: When the electronic stepless speed regulation adjusts the lifting speed, it cannot be operated too fast. Before using the 50KN power machine, pay attention to check the tightening of the clamp tightening screws. When lifting the lower clamp, the movement should be stable, avoid collision, and often check the tightness of the clamp screw. When replacing the test fixture, pay attention to cooperate to prevent bruises.

The values stated in SI units are to be regarded as the standard, with the exception of mils when determining coating thickness.Test Procedure: The haze or original weight of test specimen is measured. The test specimen is then placed on the taber wear and abrasion tester. A 250, 500, or 1000-gram load is placed on top of the abrader wheel and allowed to spin for a specified number of revolutions. Different abrading wheels are specified. A haze measurement or final weight is taken. The load and wheel can be adjusted for softer and harder materials.

Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test. Read even more details on https://www.gesterinstruments.com/.